Username:

Password:

Author Topic: Gamo G Challenger  (Read 4454 times)

Offline JS

  • Full Member
  • ***
  • Posts: 191
  • Age: 36
  • Location: Auckland
  • Mana 7
    • View Profile
Re: Gamo G Challenger
« Reply #30 on: January 15, 2019, 02:04:20 PM »
The planed two stage trigger is not going well. So far my drawings have not come up with the answer.
 Even a rough mock up doesn't work with the Gamo trigger levers.
Should have realised that in the beginning. That is why the Charlie da Tuna GRT trigger is single stage.

The Charlie da Tuna GRT trigger is a 2 stage trigger.

Does anyone know of an adjusting guide for the GRT III trigger blade for 2 stages? I admit I havent played with mine mich, but on install it was crisp single stage. A lot better than the unpredictable factory trigger but room for imporvement..
TX200 MKIII .177
Gamo Hunter 440 .22
Feinwerkbau 300s .177
Weihrauch HW80 .22
HW45 .177

Offline xyon

  • Jr. Member
  • **
  • Posts: 50
  • Location: Canterbury
  • Mana 1
    • View Profile
Re: Gamo G Challenger
« Reply #31 on: January 15, 2019, 11:57:35 PM »

Offline Novagun

  • NZ Airgun
  • Hero Member
  • *
  • Posts: 870
  • Mana -9
    • View Profile
Re: Gamo G Challenger
« Reply #32 on: January 20, 2019, 10:08:08 AM »
Yes Xyon. You are right, I looked at the web site. The GRT111 is an adjustable two stage and that works well on the old steel trigger Gamos. The GRT4G is not adjustable and the first stage built in to the trigger blade. In my gun that part does not work well but the second stage is very good.
As a two stage trigger it is not as good as the Record trigger.
With the Gamos I have the triggers are set so they work as a single stage. I prefer that and not worried about two stages. A good single stage works very well.