Username:

Password:

Author Topic: V-mach race muzzle brake  (Read 353 times)

Offline Sc0-

  • Newbie
  • *
  • Posts: 1
  • Mana 0
    • View Profile
V-mach race muzzle brake
« on: August 26, 2018, 01:09:06 PM »
Trying to fit one on my newer manufactured HW77k, am having issues. Removing the front sight block required the use of a press, heat and a wooden block didn't even budge it...

The issue is my underlever has a spring loaded wide nosed plunger. I am not seeing how the lever is retained with the Vmach front end fitted? The Vmach has a threaded hole where a spring loaded ball bearing plunger goes in, remove it and it's a large threaded hole. It does have a steel piece included with a countersink hole which I think goes into the cocking lever somehow.  Emailed V-Mach but if anyone have dealt with this before I would be appreciative on the how-to.

Offline Pauly5

  • Hero Member
  • *****
  • Posts: 1887
  • Location: Porirua
  • Mana 28
  • Go ahead, make my day!
    • View Profile
Re: V-mach race muzzle brake
« Reply #1 on: August 26, 2018, 06:55:21 PM »
Got any photos? Might help.
HW98
HW97k
Tx200
S510
HFT500
Bobcat
Matador R2.5
HW40 (copy)
Daisy 953
P-Rod
1377
Zoraki 22

Offline Novagun

  • NZ Airgun
  • Hero Member
  • *
  • Posts: 870
  • Mana -9
    • View Profile
Re: V-mach race muzzle brake
« Reply #2 on: September 22, 2018, 09:57:12 AM »
Does the threaded bit with the countersink hole not go into the muzzle brake so the detent on the cocking lever holds in onto the brake.

Second, why does an HW77 need a brake? They are pretty good as they come. Really good.
Heat and hammer on a 77--